Roland V-Synth owner manual Chorus Parameters, Reverb Parameters, Chorus Type

Effects List

Chorus Parameters

The functions of Chorus parameters are explained.

Chorus Type

01: Chorus 1

This conventional chorus effect adds spaciousness and depth to the sound. Slow modulation frequency with less depth.

02:Chorus 2

This conventional chorus effect adds spaciousness and depth to the sound. Rapid modulation frequency with less depth.

03: Chorus 3

This conventional chorus effect adds spaciousness and depth to the sound. Slow modulation frequency with more depth.

04: Chorus 4

This conventional chorus effect adds spaciousness and depth to the sound. Rapid modulation frequency with more depth.

05: Feedback Chorus

This chorus offers a flanger-like effect, creating a soft sound.

06: Flanger

This effect sounds somewhat like a jet airplane taking off and landing.

07: Short Delay

This is a delay with a short delay time.

08: Fbk Short Delay

This is a short delay with many repeats.

Chorus Parameters

Parameter	Value	Description
Pre Low Freq	500–15000 Hz,	Frequency of the low range
	THRU	(THRU: no filter is used)
Pre Hi Freq	THRU, 50–800 Hz	Frequency of the high
		range (THRU: no filter is
		used)
Pre Dly Time	0–50.0 ms	Adjusts the delay time from
		the direct sound until the
		chorus sound is heard.
Co LPF Freq	500–15000 Hz,	Adjusts the cutoff frequen-
	THRU	cy of the low pass filter.
		(THRU: no filter is used)
		The effect will be applied to
		the frequency range below
		the cutoff frequency.
Co HPF Freq	THRU, 50–800 Hz	Adjusts the cutoff frequen-
		cy of the high pass filter.
		(THRU: no filter is used)
		The effect will be applied to
		the frequency range above
		the cutoff frequency.
Rate	0.05–10.0 Hz, note	Sets the cycle for the chorus
		or flanger sound undula-
		tions.
Depth	0–127	Adjusts the depth of modu-
		lation for the chorus or
		flanger.
Feedback	-98– +98 %	Adjusts the proportion of
		the effect sound that is fed
		back into the effect. Nega-
		tive (-) settings will invert
		the phase.
Cho/Flg Sw	CHORUS,	Selects either chorus or
	FLANGER	flanger.

Reverb Parameters

The functions of Reverb parameters are explained.

Explanations for each Reverb Type are given on the following pages.

01: Room 1	(p. 139)
02: Room 2	(p. 139)
03: Room 3	(p. 140)
04: Hall 1	(p. 140)
05: Hall 2	(p. 141)
06: Hall 3	(p. 141)
07: Garage	(p. 142)
08: Plate	(p. 142)
09: Non-Linear	(p. 143)
10: Delay	(p. 143)

138