Roland V-Synth owner manual Adjusting the Sensitivity of the Time Trip Pad, 100

Other Functions

Adjusting the Sensitivity of the Time Trip Pad

Perform this adjustment if the Time Trip pad no longer responds as

you expect.

1.In the CALIBRATION MENU screen, touch <TIME TRIP PAD>.

The TT PAD CALIBRATION screen appears.

2.On the Time Trip pad, touch the points indicated by the square symbol in the screen, in the following order: left → top → right → bottom.

When you have touched all four points, the screen will close, and the sensitivity of the Time Trip pad will be calibrated.

Adjusting the Sensitivity of the D Beam Controller

Perform this adjustment if the D Beam controller is functioning

incorrectly, such as responding even though you have not operated

it.

1.In the CALIBRATION MENU screen, touch <D BEAM>.

The D Beam CALIBRATION screen appears.

When you place your hand over the D Beam controller, the “L” or “R” level meter in the screen will move upward or downward.

2.First specify the location at which the D Beam controller will begin responding (i.e., the minimum value).

Move your hand toward the D Beam controller, and touch <Min> at the point where you want the controller to begin responding.

3.Next specify the location at which the D Beam controller will reach the peak (i.e., the maximum value).

Continue moving your hand toward the D Beam controller, and touch <Max> at the point where you want the peak response to occur.

4.While watching the level meter in the screen, raise and lower your hand to check the response of the D Beam controller.

5.If you are satisfied with the response, touch <OK>.

The sensitivity of the D Beam controller will be calibrated.

100