Roland V-Synth owner manual Setting Effects for a Patch Effect, Routing

Creating a Patch

●Apply the LFO immediately when the key is pressed, and then gradually begin to decrease the effect

high (more)	Delay Time	Fade Time
Pitch
Cutoff Frequency		Depth
Level
Pan	Note on
low (less)

Fade Mode: ON >>

Fade Time: The time over which the LFO amplitude will reach the minimum after the Delay Time has elapsed.

Delay Time: The time that the LFO will continue after the keyboard

is played.

●Apply the LFO gradually after the key is released

high (more)	Delay
	Time	Fade Time
Pitch
Cutoff Frequency		Depth
Level
Pan	Note
Note
on	off
low (less)

Fade Mode: OFF <<

Fade Time: The time over which the LFO amplitude will reach the maximum after the Delay Time has elapsed.

Delay Time: The time from when the keyboard is released until the LFO begins to be applied.

●Apply the LFO from when the key is pressed until it is released, and gradually begin to decrease the effect when the key is released

high (more)		Delay
		Time	Fade Time
Pitch
Cutoff Frequency			Depth
Level
Pan
low (less)	Note on	Note off

Fade Mode: OFF >>

Fade Time: The time over which the LFO amplitude will reach the minimum after the Delay Time has elapsed.

Delay Time: The time that the LFO will continue after the keyboard

is released.

Setting Effects for a Patch (Effect)

Routing

MFX Send (MFX Send Level) ★

Sets the level of the signal sent to tMFX.

Value: 0–127

CHO Send (Chorus Send Level) ★

Sets the level of the signal sent to chorus.

Value: 0–127

REV Send (Reverb Send Level) ★

Sets the level of the signal sent to reverb.

Value: 0–127

Output Assign

Sets the direct sound’s output method.

Value

MULTI: Output in stereo through MFX. You can also apply chorus or reverb to the sound that passes through MFX.

MAIN: Output to the MAIN OUT jacks in stereo without passing through MFX.

DIR: Output to the DIRECT OUTjacks in stereo without passing through MFX. Make this setting when you want to use external effects.

MFX (MFX On/Off Switch) ◆

Switches MFX on and off.

Value: (OFF), (ON)

MFX Type

Use this parameter to select from among the 41 available MFX. For details on MFX parameters, refer to “MFX Parameters” (p. 116). Value: 00 (Thru)–41

MFX Master Level

Adjusts the volume of the sound that has passed through the MFX. Value: 0–127

50