Roland V-Synth owner manual Modifying Waveforms OSC1/ OSC2, OSC Type

Creating a Patch

Modifying Waveforms (OSC1/ OSC2)

Oscillator Switch ◆

Switches the oscillator on/off.

Value: OFF, ON

OSC Type

Analog Oscillator

PCM Oscillator

Oscillator Type

Selects the type of oscillator.

By selecting “EXT IN,” the signal that is input through the rear panel INPUT jack can be used as an oscillator. This lets you play the externally input signal from the keyboard.

Value

ANALOG: Analog Oscillator

PCM: PCM Oscillator

EXT IN: External Input Oscillator

Wave Gain

Sets the gain (amplification) of the waveform.

Value: -12– +12 dB

Waveform (Analog Oscillator Waveform)

Selects the wave upon which the sound is to be based when using an

analog oscillator.

Value

Waveform	Pulse Width	Fat (p. 44)
	(p. 44)
SAW: Sawtooth wave	O	O
SQR: Square wave	O	O
TRI: Triangle wave	O	O
SINE: Sine wave	O	O
RAMP: Ramp wave	O	O
JUNO: Modulated sawtooth wave	O	O
HQ-SAW:High quality sawtooth wave	X	X
HQ-SQR:High quality square wave	O	X
NOISE: Noise wave	O	X
	O: effective	X: ineffective

Impact (Analog Oscillator Impact)

Specifies the sharpness of the attack of the analog oscillator. Higher settings will produce a sharper attack.

Value: 0.0–4.0

Time Trip Sw (Time Trip Switch)

Selects whether Time Trip will operate (ON) or not (OFF). Value: OFF, ON

Beat Keep (Time Trip Beat Keep)

After Time Trip is operated, this selects whether you will “chase” to the beat location where you otherwise would have been if Time Trip had not been operated (ON), or whether this “chase” will not occur (OFF).

Value: OFF, ON

Waveform (PCM Oscillator Waveform)

Selects the wave upon which the sound is to be based when using a PCM oscillator.

Value: 1–999 (wave number)

When you touch <List>, the Wave List window will appear, allowing you to select the wave from the list.

When you select a wave, the wave name, encoding type, and stereo/mono will also be displayed.

Vari Sw (PCM Oscillator Vari Switch)

Switches whether the sound will be produced using Vari Phrase (ON) or linearly (OFF).

Value: OFF, ON

Start Offset (PCM Oscillator Start Offset)

Specifies the starting address of the wave.

Value: 0–**

42