Roland V-Synth owner manual Basic Touch Screen Operation

USB Mode

fig.USB_50

In this mode, you can connect the V-Synth to your computer and exchange patch or wave data.

Calibration Mode

fig.CALIBRATION_50

In this mode you can adjust the response of the touch screen and D Beam controller.

Factory Reset Mode

fig.FACTORY_50

In this mode, you can reset to default factory settings.

Demo Play Mode

fig.DEMO_50

In this mode, you can play the built-in demo songs.

Overview of the V-Synth

Basic Touch Screen Operation

The V-Synth features a touch screen. The touch screen lets you perform a variety of operations by lightly touching the screen.

The touch screen responds to a light touch. Pressing the touch screen with too much force, or with a hard object, may damage it. Be careful not to apply excessive force, and touch it only with your finger.

Enabling/Disabling the Beep Tone

You can specify whether or not a beep tone will be heard when you touch a valid point on the touch screen.

At the factory setting, the beep tone will be sounded.

1.In the upper right of the screen, touch <▼>.

A pulldown menu appears.

fig.01-05_50

2.In the pulldown menu, touch <Beep> to add a check mark (✔).

With this setting, the beep tone will be heard. If you perform the same procedure once again, the check mark will be cleared and the beep tone will no longer be heard.

If you have turned off the beep tone, a “∇ ” appears in the title area at the top of the screen when you touch a valid point on the

touch screen.

fig.01-06

Overview of the V-Synth

Demo Song: New Toys Amin Bhatia © 2002 Roland Corporation 19