Siemens S120 configurationmanual General safety guidelines Use for the intended purpose

General safety guidelines

1.3 Use for the intended purpose

1.3Use for the intended purpose

DANGER

There is a risk of death, serious personal injury and/or serious material damage when direct drives or their components are used for a purpose for which they were not intended.

The motors are designed for industrial or commercial machines. It is prohibited to use them in areas where there is a risk of explosion (Ex-zone) unless they are designed expressly for this purpose (observe the separately enclosed additional instructions where applicable). If increased demands (e.g. touch protection) are made in special cases – for use in non- commercial systems – these conditions must be ensured on the machine side during installation.

Direct drives and their components may only be used for the applications specified by the manufacturer. Please contact your Siemens branch responsible if you have any questions on this matter.

The motors must be protected from dirt and contact with aggressive substances.

Special versions and design variants whose specifications vary from the motors described herein are subject to consultation with your Siemens branch.

The motors are designed for an ambient temperature range of -5 °C to +40 °C. Any alternative requirements specified on the rating plate must be noted! The on-site conditions must comply with the rating plate specifications and the condition specifications contained in this documentation. Any differences regarding approvals or country-specific guidelines must be taken into account separately.

DANGER

The products included in the scope of delivery are exclusively designed for installation in a machine. Commissioning is prohibited until it has been established that the end product conforms with Directive 98/37/EC. All safety instructions must be observed and given to the end user for his/her information.

DANGER

Risk of electric shock if a hazardous voltage is present on the stator when operated as a single component.

To ensure that the components have sufficient shock-hazard protection, voltage must only be applied to the motors once they have been installed.

16	1FW6 Built-in torque motors
	Configuration Manual, 05/2009, 6SN1197-0AE00-0BP3