Configuration Commands
•Network Dormant: The PinPoint‐Eis connected to the 1x cellular network, but the link is dormant. It will be woken up when data is sent or received.
•No Service: There is no cellular network detected.
•Hardware Reset: The internal module is being reset. This is a temporary state.
*PRLSTATUS?
•The status of the most recent PRL Update.0 : None
•1 : In Progress
•2 : Success
•Any other value : Failure
*POWERMODE?
Displays the current power state/mode. Possible values returned are:
•Initial: The modem is in the initial 5 minutes since power up, so power down event will be ignored.
•On: Regular power on, a power down is not pending.
•Low Cancellable: Power down is pending but still cancelable if the power down trigger goes away.
•Low Pending 1 and Low Pending 2: Power down is pending, any modem tasks are gracefully preparing for the power down.
•Low Final: Power down is imminent.
•Low: Power is down.
+HWTEMP?
Displays the internal temperature of the radio module in degrees Centigrade.
+PRL?
Preferred Roaming List (PRL) version.
Information Displayed in AceManager without AT Commands Listed
•Bytes and Packets Received and Sent: Network traffic for the applicable port.
•Number of System Resets: Counter of the number of system resets over the life of the modem or since the configuration was reset.
•Bad Password Count: Counter of the number of bad password attempts.
|
|
|
|
|
|
|
Rev 3.0B Feb.08 |
|
|
|
|
| 116 |
|
|
|
