Sierra Wireless EV-DO manual Sending Reports Automatically, Remote

Global Positioning System (GPS)

•11 ‐ Global Positioning System (GPS) data.

•12 ‐ GPS data with the UTC time and date.

•13 ‐ GPS with time and date and Radio Frequency data from the antenna.

•D0 ‐ Xora reports.

•E0 ‐ NMEA GGA and VTG sentences.

•E1 ‐ NMEA GGA, RMC, and VTG sentences.

•F0 ‐ TAIP data

•F1 ‐ TAIP compact data

Tip: The PinPoint-E can be configured to supply one type of report to a remote host and a different report type locally through the serial port at same time. However, there may be conflicts due to the local and remote reporting being in different modes and not all features to both modes may be available.

Sending Reports Automatically

Remote

You can configure the PinPoint‐E to send reports based on a time interval and on the movement of a vehicle (based on it’s position from one time to the next).

Figure 9-7: AceManager : PinPoint - *PPTIME, *PPDIST, *PPTSV,

*PPMINTIME

•*PPTIME ‐ Location report sent every set time interval (seconds).

•*PPDIST ‐ Location report sent only if the position is more than the set distance (x 100 meters).

•*PPTSV ‐ Location report sent if the vehicle has been in one location (stationary) for more than a set time interval (minutes).

•*PPMINTIME ‐ Location report sent be sent at no less than this time interval (seconds).

Note: If you’re implementing both a time interval and distance interval for reports, the PinPoint-E will use the timer which expires first. The reporting interval can impact your data usage. If the interval is set frequently, you may want to have a high usage or unlimited data plan.

Rev 3.0B Feb.08 86