Configuration Commands
Qn
The AT quiet‐mode setting. If quiet mode is set, there will be no responses to AT commands except for data queried.
•n=0 : Off (Default).
•n=1 : Quiet‐mode on.
S3=n
The standard end of line character used to indicate the end of an AT command. This character is also used as the carriage return character for framing responses and result codes in command state. Cannot be configured in AceManager.
•n=0‐127 (ASCII character number)
S4=n
The standard line feed character sent by the modem to the host at the end of a response or return code in command state. Cannot be configured in AceManager.
•n=0‐127 (ASCII character number)
S5=n
This register sets the character recognized as a backspace during command entry. Cannot be configured in AceManager.
•n=0‐127 (ASCII character number)
S6=n
This register denotes the wait time, in seconds, before a blind dial (no dial tone detection). Cannot be configured in AceManager.
•n=2‐10 seconds
S8=n
Whenever a dial command contains the comma character, the contents of this register specify the pause time for each comma. Cannot be configured in AceManager.
•n=0‐255
S9=n
Specifies the time that the received carrier must be present for the modem to recognize it and turn on Data Carrier Detect (DCD) if applicable. The implementation is entirely at the IWF modem. Cannot be configured in AceManager.
•n=0‐255
|
|
|
|
|
|
|
Rev 3.0B Feb.08 |
|
|
|
|
| 124 |
|
|
|
