Global Positioning System (GPS)
RAP Reports Over-The-Air (Remote)
To configure your PinPoint‐E to send RAP reports to a remote AVL host server, you will need to set 3 commands: *PPIP, *PPPORT, and *PPGPSR.
a.Set the IP address of the host with *PPIP and desired port on the host with *PPPORT.
Figure 9-14: AceManager : PinPoint - *PPIP, *PPPORT
b.Set the GPS Report Type, using *PPGPSR, to your preferred RAP report type.
11 ‐ GPS ‐ Global Positioning System data
12 ‐ GPS + Date ‐ GPS data with the UTC time and date
13 ‐ GPS + Date + RF ‐ GPS data with the UTC time and date and Radio Frequency information from the antenna.
Figure 9-15: AceManager : PinPoint - *PPGPSR
Tip: If your AVL host server uses a dynamic IP address or needs to change its IP address for any reason, you can use the RAP configu- ration command to change the value for *PPIP.
RAP Reports over a Local Connection
Local reports are sent to the local IP address of the computer or device connected directly to a port on the PinPoint‐E. The reports are sent using PPP or SLIP for serial. To configure the modem to send reports to the local IP address, you will need to set 3 commands: S53 in the Misc group and *PPLATS and *PPLATSR in the PinPoint group.
a.Set the S53 port to the local port to which you want the reports sent. The local IP address will automatically be used.
|
|
|
|
|
|
|
Rev 3.0B Feb.08 |
|
|
|
|
| 90 |
|
|
|
