Sierra Wireless EV-DO manual String=AT commands, =1‐255 minutes, =1‐255 hours

Configuration Commands

Note: It may take up to 30 seconds for the hardware module to respond after CONNECT is output.

*CSX1=n

PassThru Echo : Echo data to the host.

•n=0 : Data will be passed to the host.

•n=1 : PASSTHRU mode will echo all host received data and will not pass the data to the modem while the modem is not asserting DCD.

Note: If the modem is asserting DCD, data will be passed from the host to the modem as it normally is when *CSX1=0.

*PTINIT=string

Any AT Command string to be passed to the OEM module before entering PASSTHRU mode, e.g. AT&S1V1, etc.

•string=AT command(s)

*PTREFRESH=n

Number of minutes of inactivity in PASSTHRU mode to resend the *PTINIT string to the hardware module.

•n=0 : Disabled

•n=1‐255 minutes

*RESETPERIOD=n

In PASSTHRU mode, modem will be reset after this period if no data has been sent or received. Value is in hours.

•n=0 : Disabled

•n=1‐255 hours

SMTP

SMTP (Simple Mail Transfer Protocol) is the de facto standard for email transmission across the Internet. The PinPoint‐E can send messages using SMTP if it has been configured to use a mail server.

Note: You cannot send an Email with your PinPoint-E unless the Email server you have configured allows your PinPoint-E as a relay host. Talk to your network administrator to ensure you can send email through the email server using your PinPoint-E.

Rev 3.0B Feb.08 138