Configuration Commands

n=minutes

*TPORT=n

Sets or queries the port used for the AT Telnet server. If 0 is specified, the AT Telnet server will be disabled. The default value is 2332.

n=0 : Disabled.

n=1‐65535

Tip: Many networks have the ports below 1024 blocked. It is recom- mended to use a higher numbered port.

*TQUIT

Disconnects the telnet session. Not available in AceManager..

Low Power

The PinPoint‐E will put itself into a low power using mode when configured events occur. Low Power mode is essentially a standby mode which uses minimal power while being ready to “come alive” quickly.

Figure 1-15: AceManager : Low Power

DTRP=n

Set or query the DTR power control. See also PTMR.

n=0 : Ignore DTR for power control.

n=1 : Enter low power mode when DTR is low.

n=2 : Enter low power mode when DTR is high.

PTMR=n

Number of minutes after one of the power down events (VTLG or DTRP) happens until the PinPoint‐E enters the low power mode. If DTRP and VLTG are both 0 (zero), this setting does nothing.

 

 

 

 

 

 

 

Rev 3.0B Feb.08

 

 

 

 

 

144

 

 

 

Page 149
Image 149
Sierra Wireless EV-DO manual Low Power, =minutes, TPORT=n, DTRP=n, PTMR=n