Introduction to the PinPoint-E

Figure 1-9: Connecting to the Internet

The PinPoint‐E will perform a one‐to‐one routing for all internet traffic to and from the computer or other end device. One‐to‐one means that your PinPoint‐E will provide a connection for one device to the Internet at a time. In Private Mode, the PinPoint‐E will provide NAT (Network Address Translation) for the computer or other end device.

Note: The PinPoint-E does not provide advanced routing required by one-to-many (several devices connected to one port). If you need to have more than one device connected to the Internet through your PinPoint-E, you will need to have a router connected to the modem. The modem would provide the one-to-one connection to the router with the router configured to provide a broader NAT service to the other devices connected to it.

Dynamic vs. Static IP Addresses

There are two types of addresses on networks: dynamic and static.

Dynamic addresses are assigned on a “need to have” basis. Your PinPoint‐E might not always receive the same address each time it connects with Verizon.

Static addresses are permanently assigned to a particular account and will always be used whenever your PinPoint‐ E connects to the Internet. The IP address will not be given to anyone else.

Most ISPs (cellular included) use dynamic IP addresses rather than static IP addresses since it allows them to reuse a smaller number of IP addresses for a large number of customers. A dynamic IP address is suitable for many common Internet uses, such as web browsing, looking up data on another computer system, or other client functions (such as data only being sent out or only being received after an initial request).

Tip: If your account with Verizon includes a dynamic IP address and you need a static IP, please consult your Verizon Representative for more information about changing your account for static IP support.

If you need to contact your PinPoint‐E, a device connected to the PinPoint‐E, or a host system using the PinPoint‐E from the Internet, you need to have a known IP (such as one which is static) or domain name (an IP address which is converted by a DNS server into a word based name). If you have a dynamic IP

 

 

 

 

 

 

 

Rev 3.0B Feb.08

 

 

 

 

 

16

 

 

 

Page 21
Image 21
Sierra Wireless EV-DO manual Dynamic vs. Static IP Addresses, Connecting to the Internet