Toshiba Three-phase 200V class 0.1 to 2.2kW instruction manual Display of trip information

E6581090

8.2Display of trip information

If the inverter trips, an error code is displayed to suggest the cause. In the status monitor mode, all trip records are retained.

■Display of trip information
	Error code	Communication No.	Description
	PGTT (*)	0000	No error
	QE	0001	Overcurrent during acceleration
	QE	0002	Overcurrent during deceleration
	QE	0003	Overcurrent during operation
	QEN	0004	Load-side overcurrent during start-up
	QEC	0005	Armature-side overcurrent during start-up
	GRJ	0008	Input phase failure
	GRJQ	0009	Output phase failure
	QR	000A	Overvoltage during acceleration
	QR	000B	Overvoltage during deceleration
	QR	000C	Overvoltage during constant-speed operation
	QN	000D	Inverter overload trip
	QN	000E	Motor overload trip
	QJ	0010	Overheat trip	8
	G	0011	Emergency stop
	GGR	0012	E2PROM fault 1
	GGR	0013	E2PROM fault 2
	GGR	0014	E2PROM fault 3
	GTT	0015	Inverter RAM fault
	GTT	0016	Inverter ROM fault
	GTT	0017	CPU fault trip
	GTT	0018	Communication error
	GTT	001A	Current detector fault
	WR	001E	Undervoltage trip
	GH	0022	Ground fault
	QER	0025	Overcurrent flowing in element during acceleration
	QER	0026	Overcurrent flowing in element during deceleration
	QER	0027	Overcurrent flowing in element during low-speed operation
	G	0032	Trip caused by a break in an analog signal cable
	G	0033	CPU communication error
	G	0034	Excessive torque boosted

(Note) Past trip records (trip records retained or trips that occurred in the past) can be called up. (Refer to 8.1 "Status monitor mode" for the call-up procedure.)

(*)Strictly speaking, this code is not an error code; this code is displayed to show the absence of error when the past trip monitor mode is selected.

H-3