Toshiba Three-phase 200V class 0.1 to 2.2kW HJ Maximum frequency Hz, Parameter setting

E6581090

5.6Maximum frequency

HJ : Maximum frequency (Hz)

• Function

1) Programs the range of frequencies output by the inverter (maximum output values).

2) This frequency is used as the reference for acceleration/deceleration time.

Output frequency (Hz)	When HJ = 80Hz		•	This function determines the
80Hz				maximum value in line with the
				ratings of the motor and load.
60Hz	When HJ = 60Hz		•	Maximum frequency cannot be
				adjusted during operation. To
5				adjust, first stop the inverter.
0	100%	Frequency setting signal (%)

★If HJ is increased, adjust the upper limit frequency WN as necessary.

■Parameter setting

Title	Function		Adjustment range	Default setting
HJ	Maximum frequency (Hz)	30.0～200 (Hz)		*

*The value is changed according to the set-up parameter condition. (VFNC1 (S)-□□□□P□-W type)

80 [Hz] for VFNC1 (S)-□□□□P□-W type.

5.7Upper limit and lower limit frequencies

WN : Upper limit frequency (Hz)

NN : Lower limit frequency (Hz)

• Function

Programs the lower limit frequency that determines the lower limit of the output frequency and the upper limit frequency that determines the upper limit of that frequency.

Output frequency (Hz)	Upper limit
	frequency

HJ

WN

0100%

Frequency setting signal

★ Signals with a frequency higher than the frequency set with WN will not be put out.

Output frequency (Hz)	Lower limit
	frequency

HJ

NN

0 Frequency setting signal100%

★ The output frequency cannot be set below the frequency set with NN.

■Parameter setting

Title	Function	Adjustment range	Default setting
WN	Upper limit frequency (Hz)	0.5～HJ (Hz)	*
NN	Lower limit frequency (Hz)	0.0～WN (Hz)	0.0

*The value is changed according to the set-up parameter condition. (VFNC1 (S)-□□□□P□-W type)

80 [Hz] for VFNC1 (S)-□□□□P□-W type.

E-6