Toshiba Single-phase 100V class 0.1 to 0.75kW Table of output terminal functions

E6581090

■Table of input terminal functions 3

*2

*2

*2

*2

58	SS1+AD2	Combination of preset speed command	ON	: Simultaneous input of SS1 and
58		1 and acceleration/deceleration 2		AD2 commands
57	SS2+AD2	Combination of preset speed command	ON	: Simultaneous input of SS2 and
59		2 and acceleration/deceleration 2		AD2 commands
57	SS3+AD2	Combination of preset speed command	ON	: Simultaneous input of SS3 and
60		3 and acceleration/deceleration 2		AD2 commands
61	SS4+AD2	Combination of preset speed command	ON	: Simultaneous input of SS4 and
		4 and acceleration/deceleration 2		AD2 commands

*2 This function is effective after software version V120.

■Table of output terminal functions 1

Function	Code	Function	Action
No.
0	LL	Frequency lower limit	ON : Output frequency higher than  setting
			OFF : Output frequency equal to or lower than 
			setting
1	LLN	Inversion of frequency lower limit	Inverse output of LL
2	UL	Frequency upper limit	ON : Output frequency equal to or higher than 
			setting
			OFF : Output frequency lower than  setting
3	ULN	Inversion of frequency upper limit	Inverse output of UL
		Low-speed detection signal	ON : Output frequency equal to or higher than
4	LOW		 setting
			OFF : Output frequency lower than  setting
5	LOWN	Inversion of low-speed detection	Inverse output of LOW
		signal
		Designated frequency reach	ON : Output frequency within command frequency
			±2.5Hz
6	RCH	signal (completion of		11
			OFF : Output frequency exceeding command
		acceleration/deceleration)
			frequency ±2.5Hz
		Inversion of designated
7	RCHN	frequency reach signal (inversion	Inverse output of RCH
		of completion of
		acceleration/deceleration)
			ON : Output frequency within  setting
8	RCHF	Set frequency reach signal	±2.5Hz
			OFF : Output frequency exceeding  setting
			±2.5Hz
9	RCHFN	Inversion of set frequency reach	Inverse output of RCHF
		signal
10	FL	Failure FL (trip output)	ON : Inverter trips
11	FLN	Inversion of failure FL (inversion	Inverse output of FL
		of trip output)
12	OT	Over-torque detection	ON : Torque current is held above the torque set
			with  for a period of time longer than
			that set with .
13	OTN	Inversion of over-torque	Inverse output of OT
		detection

K-11