Toshiba Single-phase 100V class 0.1 to 0.75kW RUN Motor starts Motor stops slowdown stop

E6581090

3.1.1How to start and stop

(1) Start and stop using the operation panel keys (EOQF : )

Use the RUN and STOP keys on the operation panel to start and stop the motor.

RUN : Motor starts.
	: Motor stops (slowdown stop).
STOP		3

(2)Start and stop using external signals to the terminal board (EOQF : )

Use external signals to the inverter terminal board to start and stop the motor. (Sink logic connection)

Short F and CC terminals: run forward		★Coast stop
		The standard default setting is for slowdown
		stop. To make a coast stop, assign an ST
Open F and CC terminals: slow down and stop		terminal function to an idle terminal using the
		programmable terminal function.
		For coast stop, open the ST-CC when stopping
		the motor in the state described at left. The
		monitor on the inverter at this time will display
Frequency	Slowdown stop	QHH.
	ON	Motor	Coast stop
F-CC		speed
	OFF
		F-CC		ON
				OFF
		ST-CC		ON
				OFF

3.1.2How to set the frequency

(1)Setting the frequency using the potentiometer on the inverter main unit

(HOQF : )

Set the frequency with the notches on the potentiometer.

Move clockwise through the higher notches for the higher frequencies.

Since the potentiometer has hysteresis, it settings may change to some degree after the power is turned off and turned back on.

C-3