Section 4 | Novell NetWare Network Configuration |
Configuring the
Print Server and
Print Queue
Using
PCONSOLE and
XCONFIG (cont.)
5.Run the XConfig utility (if you do not have it installed, it can be downloaded from the TROY web site at http://www.troygroup.com/wireless).
6.Select the TROY PocketPro 100S from the list of print servers. When you get the message that the print server is connected, press the ENTER key and type the password ACCESS in response to the "#" prompt (the password will not echo), and then press the ENTER key again in response to the Enter Username> prompt. When you get the Local> prompt, type:
SET NET NPRINTER nlm number ON service
SET NET RESCAN
EXIT
The nlm is the name of the PSERVER NLM on your file server, number is the printer number (must match the printer number you selected during the PCONSOLE configuration in the previous steps) and service is the name of the service (the default service name is listed in the Default Print Server Names section of this chapter). For example, to set up remote printer 3 for an HP printer with the TROY print server TWC_00C3E4 using the PSERVER NLM called TROY1PS, you would type:
SET NET NPRINTER XCD1PS 3 ON TWC_00C3E4_P1
SET NET RESCAN
EXIT
NOTE: The same service cannot be used for both queue server mode and remote printer mode. Refer to Appendix B in this manual for information on using services.
7.You must now unload the PSERVER NLM from your NetWare file server console, and then reload it in order for the changes to take effect.
PocketPro 100S Administrator’s Guide |
