TROY Group 100S manual Downloading from a NetWare Server Obtaining Firmware Updates

Appendix C Reloading the Firmware

Downloading from a NetWare Server

Obtaining

Firmware

Updates

To download from a NetWare server, first copy the firmware update file into the \login directory on your SYS partition (SYS:\LOGIN). Using the \login directory will eliminate any potential file protection problems.

Connect to the print server remote console using XCONFIG (refer to Appendix A for more information on using commands) and enter the following commands in response to Local> prompt.

SET LOAD		HOST fileservername
SET	LOAD	SOFTWARE SYS:\LOGIN\TROY.BIN
SET	LOAD	ENABLE

The fileservername is the name of the file server. Substitute the actual name of your firmware update file for "TROY.BIN". When you type a CTRL-D to exit the remote console, the file TROY.BIN will then be loaded into the print server. The red diagnostic LED will blink during the load process and will go out when the process is complete.

If the red LED does not go out after about two minutes, check to make sure that you correctly entered all parameters and that your network connections are good. Then power the print server off and then on again, enter the SET LOAD ENABLE command, and exit the remote console to retry the download.

To get the latest firmware updates for your TROY PocketPro 100S print server, go to the Tech Support pages on the TROY web site at http://www.troygroup.com/wireless.

If you do not have Internet access, you may contact TROY Tech Support at (800) 332-6427, fax (304) 232-0996, or send an e-mail using the following address: technicalsupport@troygroup.com. The firmware can be mailed to you on a diskette or electronically sent to you.

PocketPro 100S Administrator’s Guide -- Document #40165-110 Rev. A C-9