![](/images/new-backgrounds/1148853/148853251x1.webp)
Section 8 | IPP Configuration |
Introduction
Windows
2000 IPP
Configuration
Configuring IPP on Other Operating Systems
This chapter describes procedures for IPP Configuration. The Internet Printing Protocol (IPP) allows you to print over local area networks (LANs). IPP is currently included with newer Windows operating systems.
The following steps are required to use IPP with Windows and the TROY PocketPro 100S. Make sure that the print server is powered on and configured with a valid IP address (refer to Section 3 for information on how to configure the IP address). Note that the printer cannot be configured unless the Windows 2000 server can communicate with the print server.
1.Go to the Start button, and then click on Printers.
2.
3.Click on Next.
4.Select Network Printer, and then click on Next.
5.Select Connect to a Printer on the Internet or on your Intranet. Enter the URL of the print server along with the service name (BINARY_P1 is the default service). For example:
http://192.189.207.99/BINARY_P1
6.It may take a couple of minutes to find the print server. You may also get a message that the correct driver is not installed; if so, click on OK to install the driver, and then select the appropriate printer.
7.Select the printer type, and then click on Next.
8.If desired, make the printer the default printer, and then click on Next.
9.Click on Finish. You are now ready to use the IPP printer.
IPP is beginning to be implemented on other operating systems. The procedures for configuring the IPP print queue varies from system to system; but in all cases, you must specify the URL of the print server. This address has the following format:
http://ipaddress/service
The ipaddress is the IP address of the print server and service is a service on the print server that is enabled for IPP. By default, the BINARY_P1 service is enabled for IPP. An example of a valid URL would be:
http://192.189.207.253/BINARY_P1
PocketPro 100S Administrator’s Guide |