Section 3 | TCP/IP Network Configuration |
Raw TCP Ports (cont.)
Changing the Configuration
(Optional)
5.Enter the desired name for the TROY print server or IP address at the Enter the network printer name/IP Name prompt.
NOTE: You will get a message “Unknown printer”. Do you wish to continue?". Enter "Y" to continue.
6.Select the printer type (for example, “HP LaserJet IIISi Printers”).
7.If desired, change any of the configurable parameters (note that the default queue name is the name of the printer plus an “_” and a number (e.g., laser_1)). Then enter 0 to configure the queue.
8.Answer “Y” at the “OK to Continue?” prompt. Exit the JetAdmin utility by pressing RETURN and then “q” twice.
Print a job using the lp command. For example,
lp
If you need a different TCP port number or if you want additional TCP ports, you may define a TCP port number on any TROY print server service by using the following command:
SET SERVICE servicename TCP nn
The servicename is the name of the service, and nn is the desired port number (must be greater than 1023). Refer to Appendix A for information on using services.
You may use TELNET, the XCONFIG NetWare utility to connect to the TROY PocketPro 100S remote console and change the configuration or view the status. The procedure and configuration commands are described in Appendix A.
PocketPro 100S Administrator’s Guide |
