Section 3 | TCP/IP Network Configuration |
Other Non-
Standard
Configuration
Options
With DEC TCP/IP Services for VMS (UCX), you first need to put a name for the TROY PocketPro 100S in the HOSTS file using the command SET HOST name /ADDRESS=ipaddress at the UCX> prompt, where name is the desired name for the print server and ipaddress is the IP address for the print server. Then use the sys$system:ucx$lprsetup command to add a printer (print queue). Enter the desired printer name, and then use the TROY print server name as the remote system name. Specify one of the TROY print server services (see beginning of this section for options) as the remote system printer name (accept the defaults for other questions).
Process Software's TCPware simply uses the VMS INIT/QUEU command with their special symbiont in the following format:
INIT/QUEUE/PROC=TCPWARE_TSSSYM/ON="host,port" queue
The host is the IP address or name of the TROY print server, port is the TROY print server raw TCP port number (9100 for the parallel port), and queue is the VMS queue name.
TGV's Multinet requires you to run the MULTINET CONFIGURE /PRINTERS command, then use the ADD command to add a printer, specifying the TROY print server IP address, a protocol type of LPD, and one of the service options described at the beginning of this section as the remote print queue.
With Wollongong's PATHWAY, first make sure that you have the Access option with lpd enabled. Then enter the print server name and IP address in the TWG$TCP:[NETDIST.ETC]HOSTS. file, run the LPGEN program, and execute the command add queue/rmachine=troyname/rprinter=service, where queue is the name of the queue, troyname is the TROY print server name from the hosts file, and service is the TROY print server service name.
To use a TROY PocketPro 100S with an IBM AS/400 running IBM’s TCP/IP Gateway Services for OS/400 (the OS/400 system must be v3.1 or later):
1.Assign a TCP/IP address to the AS/400 and the TROY PocketPro 100S.
2.Use the CFGTCP command at your OS/400 prompt to add the print server’s TCP/IP address to the AS/400 host table.
PocketPro 100S Administrator’s Guide |
