Flash Memory

4

5

6

7

8

Hold the SIMM with the connection points pointing toward the connector and position the notch as shown.

Insert the SIMM all the way into the connector at a 45° angle, and rotate it up until it snaps into place.

You can hear the memory SIMM click into place.

Make sure both metal clips on the connector are fastened, and the two pins on each end of the connector are pushed through the holes on the SIMM.

Replace the code SIMM card in the connector.

The code SIMM card installs exactly like the flash memory option. See the section “Installing a Flash Memory SIMM” on the previous page.

Continue with the section “Closing the System Board from the Rear” on the next page.

C-12 DocuPrint C20/NC20 User Guide

Page 142
Image 142
Xerox C20 manual You can hear the memory Simm click into place