5: ZXP Series Toolbox

Cleaning

Front Card Path

When you Click the Clean button, instructions will appear in the following sequence:

1.Insert a Y Roller Cleaning Card in the front feed slot, and click the Clean button.

2.Wait until the cleaning process completes. The card will eject through the front feed slot.

3.Flip the cleaning card. Insert the card through front feed slot, and click the Clean button.

4.Wait until the cleaning process completes. The card will eject through the front feed slot.

5.Observe the message, Front card path cleaning has been completed successfully.

6.Click the Close button to conclude the front card path cleaning process.

Heater Rollers

When you Click the Clean button, instructions will appear in the following sequence:

1.Open the printer cover, remove the transfer film, and close the cover. Then, click the Next button.

2.Wait until the transfer temperature falls below 70o C.

3.Remove the backing from the Hot Roller Cleaning Card. Insert the card in the front feed slot, and click the Clean button.

4.Wait until the cleaning process is completed. The card will be ejected through the front feed slot.

5.Flip the cleaning card. Insert card in the front feed slot, and click the Clean button.

6.Wait until cleaning process is completed. The card will be ejected through the front feed slot.

7.Remove the cleaning card. Open the printer cover, and install the transfer film. Close the printer cover, and click the Close button to complete the cleaning cycle.

P1045430-002

Zebra ZXP Series 8 Card Printer User’s Manual

119

Page 123
Image 123
Zebra Technologies 8 user manual Front Card Path, Heater Rollers