Zebra Technologies 8 user manual Using Partial-Width Laminate, Back F Card

2: Installation and Setup

Loading the Laminate

Using Partial-Width Laminate

Note • Since partial-width laminates are only used for the back (i.e., lower) surface of the card, this section only applies to the dual-sided laminator.

Laminates come in three widths:

“Full-Width” laminate is 2 in (51 mm) wide. The full-width laminate is used on the front (i.e., upper) or back (i.e., lower) surface of the card.

“Partial-Width” laminate is available in two widths:

•1.66 in (42 mm) wide laminate is used for cards with a writable signature panel

•1.33 in (33 mm) wide laminate is used for cards with a magnetic stripe

For either partial-width laminate, a collar on the spool keeps the laminate positioned correctly.

2“

Full-Width

1.66“ BACKF CARD

Signature Panel

1.3”

	Magnetic Stripe
P1045430-002	Zebra ZXP Series 8 Card Printer User’s Manual	31