Appendix H 
Packing the Printer with
Laminator for Shipment
Introduction
If the printer is to be shipped, it is important to use the original packing and shipping material to prevent damage to the Printer.
If the original material is lost, a replacement Shipping Kit can be ordered from Zebra; see the Spare Part Kits listing in the Service Manual, or check the Partner Zone at
www.zebra.com.
Procedure
Note • The specifics of the shipment and the printer’s condition may influence which of the following steps are followed; common sense should prevail.
Step 1. | Remove any cards from the Input and Output Hoppers. |
Step 2. | If the unit still has power applied and is turned on and is still connected to the |
| host computer, set the unit’s power switch (on the back of the printer part of the unit) |
| to the OFF ( ) position; and disconnect the interface and power cables. |
Step 3. | Open the printer door, and remove the print ribbon and transfer film. If you wish to |
| save the print ribbon and transfer film for future use, we suggest you place them in |
| sealable plastic bags for storage so they do not dry out or get dirty. |
Step 4. | Remove the cleaning cartridge and cleaning roller, and place them in the cutouts in |
| the lower foam insert. |
Zebra ZXP Series 8 Card Printer User’s Manual | 215 |
