5:ZXP Series Toolbox Cleaning
Clean Laminator
The Clean Laminator screen gives you the option to clean the laminator via the Toolbox; refer to Section 6, for cleaning via the OCP.
•Laminator Card Path (see Cleaning: Laminator on page 135).
When you click the Clean button, instructions will appear in the following sequence:
1.Wait until the transfer temperature falls below 60oC.
2.Open the laminator cover, remove the laminates (top and bottom cassettes), and close the cover; then, click on the OK button.
3.Remove the card hopper, and click on the OK button.
4.Insert the Laminator Cleaning Card in the side slot where the card hopper was located. Click on the OK button after inserting the cleaning card.
5.Wait until the cleaning process completes. The card will eject through the side slot.
6.Observe the message, Laminator cleaning has been completed successfully.
7.Open the laminator cover, install the laminates, and close the cover.
8.Click the Close button to conclude the card transport roller cleaning process.
120 | Zebra ZXP Series 8 Card Printer User’s Manual |
