ENGLISH
ON/OFF switch
•To turn the motor ON:
Press and hold the ON/OFF switch (43).
•To turn the motor OFF: Release the ON/OFF switch.
43
Rotating table
For mitre cuts the rotating table (44) can, after loosening the lock screw (46) and the table lock lever (45), be rotated 47° to the left or 47° to the right.
44 | 45 | 46 |
The rotating table engages into positive stops at the 0°, 15°, 22.5°, 30°, and 45 ° position.
A Caution!
To keep the mitre angle from changing while sawing, the lock screw of the rotating table must be tightened.
Push/pull action
The track arm permits the cutting of workpieces having a larger cross sec- tion. The track arm can be used for all type of cuts (standard cross cuts, mitre cuts, bevel cuts, compound mitre cuts).
47
When it is not required, arrest the track arm with the lock screw (47).
Cutting depth limiter
Together with the track arm, the cutting depth limiter (48) makes grooving possi- ble.
48
Bevel tilt setting
After loosening the locking lever (49) at the rear, the track arm holder can be tilted up to 45° out of vertical to the left.
49
A Caution!
When being rotated, the rotat- ing table may block if the ratchet lock- ing lever collides with the rear machine foot. Therefore the lever position should be adjusted (pull out and turn) to have sufficient clearance between lever and machine foot.
A Caution!
To keep the bevel angle from changing while sawing, the locking lever of the track arm holder must be tightened.
7. Initial Operation
7.1Rotating Table Lock Screw Installation
•Insert the lock screw (50) and turn until tight.
22