Talk Set

This function allows you to use the 965DSP as a Talk Set on active pairs or to send DTMF tones on inactive pairs.

Connect the red and black leads to the pair for lines using Loop Start. Also connect the green lead to ground on Ground Start lines.

This screen displays the last number dialed, the DC voltage on the line, and the signal format for dialing. The blue keys become number keys in the Talk Set.

Use the [Setup] key to change the Dial or Start mode or to select and edit a stored phone number (see Talk Set Setup page 136).

Use the [Tab] key to switch between on-hook and off-hook.

Use the [Enter] key to dial the number in the display. You may also manually enter numbers and they will be sent out on the line. You may also get a stored number from memory (see Talk Set Setup page 136) and then send it.

Note: Pulse dial can only be used “on-hook.”

Use the [Right] arrow key to turn the microphone on and off. Use the [Up] and [Down] arrow keys to adjust the volume. The maximum volume is limited in the Talk Set function to prevent unwanted feedback (squealing).

Use the [Return] key to exit the Talk Set before going to another function.

135

Page 135
Image 135
3M 965DPS instruction manual Talk Set