ADSL Setup
Use ADSL setup to select the desired test type, ADSL service type, and to enable or disable Pass/Fail thresholds. Use the [Tab] key to move between fields and the [Up]/[Down] arrows to select an option.
Select Captured Test to set up a link, measure the line performance, and drop the line automatically to save battery life. The data screens in Captured Test mode are ‘snapshots’ of the line performance when the connection completes.
Select Continuous Test to stay on the line for up to ten minutes to see if any problems start after the line has been up for awhile. In Continuous Test mode the screens are all ‘live’ and display continuously updated data.
Select the desired ADSL Service: G.DMT (full rate), G.Lite (splitterless), ANSI (frequency division multiplexing mode), or Multimode (automatically selects the same mode as the DSLAM).
Select Threshold On or Off to enable or disable automatic Pass/Fail thresholds in Captured Test mode only. Use the Thresholds key to edit the threshold levels.
Press the Selftest key to run a diagnostic test on the ADSL modem in the 965DSP.
Threshold Setup
Use this feature to set the acceptable data rate and capacity factor for the ADSL service grade that you are providing. The ADSL connect rate in each direction has to meet or exceed the value in the corresponding Rate field to pass. Enter the
75
