If there is a problem with the connections, you will see the “Hookup Error” screen.
There are two possible single pair hookup errors:
1)the Fault is greater than 20 MΩ, or
2)the red/green strap is bad.
The screen will show the combination of errors that have been detected. Correct the errors and press the [Enter] key to repeat the test. The measurement will begin and the results screen will be displayed.
RFL Setup: Single Section
Use the RFL Setup to change Wire Gauge and/or the cable Temperature or enter a known Distance to Strap.
Press the [Setup] key to display the current settings.
63
