Page 102 AD-4402
9.5.
9.5.9.5.
9.5. Remote Operation
Remote OperationRemote Operation
Remote Operation
The mode can read and write the parameters of function list, data of material code
and recipe code and calibration data.
The build-in RS-485, RS-422/485 (OP-03) or RS-232C (OP-04) is used for the
remote operation.
It is necessary to install the remote setup program in the computer or controller
before use. Refer to http://www.aandd.co.jp
Refer to the instruction manual for the details of the program.
Caution
Do not down load data during a weighing operation.
Remove all connections to prevent a irregular operation.
Maintain the power supply during the remote operation.
Entering to the Remote Operation Mode
Step 1 Press and hold the ENTER key and press the key.
Step 2 Press the key to select menu remote operation. And press the ENTER
key.
Advise
The following RS-232C to RS-485 converter can use.
AD-7491, other converter on the market.