A&D PD4000243 manual Category address Function Function setting Sequence Timer

Category			Range
address	Name	Descriptions	and	Default
symbol			choices
		0: Off at next start
		(Turning off until next start)
	Batch finish output	1: Off at over or unstable.
5q f-21		(Turning off when "out of range" or	0 to 2	0
	off
		"unstable condition")
		2: Off at zero band.
		(Turning off at zero band)

Category address: [Function] - [Function setting] - [Sequence] - [Timer]

Category			Range
address	Name	Descriptions	and	Default
symbol			choices
		Set the upper limit of the time of
	Batch monitoring	sequence.	0 to	0 s
5q f-31		If the sequence is not finnished,
	timer		65535 s
		sequence error SQ.ERR4 is displayed.
		If 0 is set, the timer does not work.
5q f-32	Batch start delay	Set the delay time between start	0.0 to	0.0 s
	timer	operation and the flow start	65535 s
	Full flow	The timer to prevent weighing error due	0.0 to	0.0 s
5q f-33	comparison	to vibration of open/close operation.	25.5 s
	interrupt timer	While the timer is not up, the
	Medium flow
		comparison does not work.	0.0 to	0.0 s
5q f-34	comparison
			25.5 s
	interrupt timer
	Dribble flow		0.0 to	0.0 s
5q f-35	comparison
			25.5 s
	interrupt timer
		Set the time until the dribble flow is can
	Drible flow auto-	stant.	0.0 to	3.0 s
5q f-36	Free Fall override	Use to prevent compensation error of
			25.5 s
	time	automatic free fall compensation or
		real time free fall compensation.
		Set the time between closing dribble	0.1to	0.1 s
5q f-37	Eval delay timer	flow and comparing the result. Refer to
			25.5 s
		Eval conditions [5q f-13]
	Discharge start	Set the time between operating	0.0 to	0.0 s
5q f-38		discharge start and openning the
	delay timer		25.5 s
		discahrge gate

Page 116 AD-4402