The function assigned to terminals

The function of the terminal can assign arbitrarily. Refer to 10.4. Parameter list of the Function list

8.1.2.Timing Chart

Caution

Keep the delay time to avoid mis-operation and noise.

Set the Communication mode in [01 f- 3] [without 5].

The transmission of BCD data synchronizes with displaying it in the following modes. Stream mode, auto print mode, manual print mode and accumulation print.

Exmaple

Approx. 10 ms from new data edge to strobe signal.

Data output

Strobe signal

Hold input command

Approx. 20 ms width

Max. 50 ms delay time to

 

release the hold command.

Max. 50 ms delay time until holding data

10ms/div

AD-4402

Page 73

Page 75
Image 75
A&D PD4000243 manual Timing Chart, Function assigned to terminals