Agilent Technologies 85330A service manual Output @RfSYSTLANG Scpi

Programming

		Programming Examples
1094	!
1095	OUTPUT @Rf;”SYST:LANG SCPI;”
1096	OUTPUT @Lo;”SYST:LANG SCPI;”
1097	!
1098	! Place the source in STEP mode (or LIST mode).
1099	!
1100	OUTPUT @Rf;”FREQ:MODE SWE;”
1101	OUTPUT @Rf;”SWE:GEN STEP;”
1102	OUTPUT @Lo;”FREQ:MODE SWE;”
1103	OUTPUT @Lo;”SWE:GEN STEP;”
1104	!
1105	! Set the Start, Stop, and number of points.		Ths LO source must be offset
1106	! by 20 MHz from the RF source.
1107	!
1108	OUTPUT @Rf;”FREQ:STAR “;Freq_start;” GHZ;”
1109	OUTPUT @Rf;”FREQ:STOP “;Freq_stop;” GHZ;”
1110	OUTPUT @Rf;”SWE:POIN “;Freq_pts;”;”
1111	OUTPUT @Lo;”FREQ:STAR “;Freq_start+Freq_offset;” GHZ;”			! The LO source is
1112	OUTPUT @Lo;”FREQ:STOP “;Freq_stop+Freq_offset;” GHZ;”			! offset by 20 MHz.
1113	OUTPUT @Lo;”SWE:POIN “;Freq_pts;”;”
1114	!
1115	! The step sweep points triggering is external so that the HP 85330A can
1116	! trigger the sources.
1117	!
1118	OUTPUT @Rf;”SWE:TRIG:SOUR EXT;”
1119	OUTPUT @Lo;”SWE:TRIG:SOUR EXT;”
1120	!
1121	! The start sweep trigger is AUTO.
1122	!
1123	OUTPUT @Rf;”TRIG:SOUR IMM;”
1124	OUTPUT @Lo;”TRIG:SOUR IMM;”
1125	!
1126	! Set the power level and turn the power on.
1127	!
1128	OUTPUT @Rf;”POW:LEV -5;”
1129	OUTPUT @Lo;”POW:LEV 10;”
1130	OUTPUT @Rf;”POW:STAT ON;”
1131	OUTPUT @Lo;”POW:STAT ON;”
1132	!
1133	! Don’t initiate the sweep yet...
1134	!
1135	!
1136	Set_85330a:!
1137	!
1138	OUTPUT @Hp85330a;”*RST;”	! SOFT RESET
1139	!
1140	OUTPUT @Hp85330a;”RUNT:EVEN:TRIG TTL;”		! Set the triggering.
1141	OUTPUT @Hp85330a;”RUNT:EVEN:COUN “;Angle_pts;”;” ! No of angle increments
1142	!

85330A Multiple Channel Controller 6-31