Agilent Technologies 85330A service manual Recommended Equipment, Required Equipment

Performance Verification

Recommended Equipment

Table 2-1lists the equipment that is mandatory when performing the performance verification.

Table 2-1 Required Equipment

Qty	Item	Agilent Part or Model Number1
1	Downloadable Driver Disk, rev A.03.00	85330-100162
1	Multimeter (20 Vdc, digital)	E2377A

1

1

3

1

1

1

Digital Oscilloscope (100 MHz bandwidth	54501A
1 MHz Single-shot bandwidth)
Tee adapter (BNC male to female, female)	1250-0781
Cable (BNC male to male 122 cm)	8120-1840
Network Analyzer System3	8722C (Option 003)
(50 MHz to 40 GHz4, 5
90 dB dynamic range)
Plotter or Printer6	HP 7550A+, or LaserJet
Torque wrench (2.4/3.5 mm @ 8 in-lb)	8710-17657

1.Other part numbers or model numbers may be used if they meet the minimum requirements.

2.Included with 85330A shipment.

3.System must include vector network analyzer, test port cables, and a calibration kit.

4.A 50 MHz to 26.5 GHz network analyzer may be used if the 3.5 mm adapters are used with the microwave switches.

5.If a network analyzer is used with a frequency range less than the switches, the performance verification will only be valid over the frequency range of the network analyzer.

6.Plotter or printer must be connected to the network analyzer and oscilloscope for test documentation.

7.Use this wrench for any 2.4/3.5 /SMA mm connections in this procedure.

2-2 85330A Multiple Channel Controller