Agilent Technologies 85330A service manual RUNTimeINITiateIMM, RUNTimeSOURceCOUNt

Remote Programming Command Reference

Standard Command Reference

RUNTime:INITiate:IMM

Default

Syntax

Example

Initiates the run-time sequence and control of a measurement. All parameters must be set up prior to initiating RUNT:INIT:IMM. Once the measurement is initiated, it will run until completion or until a timeout has occurred. If a timeout does occur, it will report the error to the error stack.

The event trigger is defaulted to TTL. See other related commands for their defaults.

RUNTime:INITiate:IMM;

RUNT:INIT:IMM;

	RUNTime:SOURce:COUNt
	Set the number of frequency points to be measured during the run-time
	sequence. For each frequency point, each entry in the scan list will be
	asserted and a trigger issued. If the SOURCE triggering method is IMM, no
	source TTL trigger signal is issued and the 8530A is assumed to control the
	sources. If the source triggering is TTL, a TTL signal is issued and the
	run-time sequence waits for the source ready line.
Default	The default is 1.
Syntax	RUNTime:SOURce:COUNt <number of frequency points>;
Example	RUNT:SOUR:COUN 1;
	RUNT:SOUR:COUN 51;
NOTE	For CW angle scan measurements the number of frequencies should be set
	to 1.

7-10 85330A Multiple Channel Controller