Agilent Technologies 85330A Standard Command Reference, ROUTeCLOSe, Subsystem Command Syntax

Subsystem Command Syntax

Remote Programming Command Reference

Standard Command Reference

Standard Command Reference

The following pages describe 85330A multiple channel controller standard commands.

ROUTe

:CLOSe port,(@switch address [,switch address]);

:DELay <micro-seconds>;

:CONTrol <data>;

ROUTe:CLOSe

Default

Syntax

Closes individual switch states in direct control only. The parameters are the switch port address, 1 or 2 and the switch address. The switch address is the concatenation of the SCU address and the channel. Examples are provided earlier in this chapter.

This command can also be used to set the TTL level of the rear panel AUX 2 connector before entering run-time mode.

All switch modules are set to channel 1. AUX 2 connector default is TTL LOW.

ROUTe:CLOSe 12,(@ <switch address, or list of switch addresses>); or

ROUTe:CLOSe 3,(@01);

Example	OUTPUT 70918;”ROUT:CLOS 1,(@102);”
	Closes SCU address 1 channel 2.
	OUTPUT 70918;”ROUT:CLOS 3,(@0);”
	Sets AUX 2 to TTL LOW before run-time.
NOTE	Multiple switch address entries may be:
	• Separated by commas if listing each switch address.
	• Separated by a colon for starting and ending switch addresses. Switch
	address lists may contain both comma and colon separators.

85330A Multiple Channel Controller 7-5