
Default
Syntax
Example
NOTE
Default
Syntax
Example
NOTE
Remote Programming Command Reference
Standard Command Reference
RUNTime:CONTroller
This command sets the multiple channel controller as the master CONTroller or the REMote1 or REMote2 controller. When the multiple channel controller is INITiated to the RUNTime mode, the controller will execute a sequence based on its CONTroller status.
Default is CONTroller.
RUNT:CONT CONT REM1 REM2;
RUNT:CONT CONT;
(This command is in revision A.02.31 or greater.) See “To Use
RUNTime:EVENt:COUNt
Set the number of increment angles to be measured during
Default is 1.
RUNT:EVEN:COUN <number of angular increments>;
RUNT:EVEN:COUN 91;
RUNT:EVEN:COUN 1;
When performing a frequency response measurement at a single angle the increment would typically be set to 1. This is useful for taking a frequency response measurement at a single angle, determining the measurement time of frequency response measurement, or taking a “first” sweep for the Agilent
85330A Multiple Channel Controller |