Agilent Technologies 85330A service manual Run-Time Measurement Sequence for Multiple Controllers

Programming

To Use Run-Time Control Mode

Run-Time Measurement Sequence for Multiple Controllers

Using IMM vs. TTL Trigger for Source 1

The run-time measurement sequence for multiple controllers is similar to a single controller shown earlier. See “Starting Run-Time Mode” on page 6-14for more information on this sequence. The sequence for multiple controllers has additional steps to allow communications between the controllers. Refer to Figure 6-3 on page 6-19and Figure 6-4 on page 6-20for the actual run-time measurement sequence.

Refer to “Source 1 IMM, TTL or REM1 trigger diamond in Figure 6-3.

When using multi frequencies:

•The RF Source controlled by the master 85330A should use the TTL trigger.

•The other RF Source (not controlled by the master 85330A) should use the IMM trigger.

6-18 85330A Multiple Channel Controller