Agilent Technologies B2201A manual Switch Control Commands Functions, Card No, Channel No

									Programming
								Programming Basics
	Switch Control
	The following commands are used to control open/close of the specified switch.
Table 4-2	Switch Control Commands
				Functions				Commands
	Closes the relays specified by channel_list.						:ROUT:CLOS channel_list
	Opens the relays specified by channel_list.						:ROUT:OPEN channel_list
	Opens the all relays on the card specified						:ROUT:OPEN:CARD card_no
	by card_no.
	The channel_list is the parameter which determines the input-output cross points to
	open/close. Figure 4-1 shows the basic syntax of the channel_list parameter.
	In the channel_list, you can specify one or more channels. Each specified channel
	consists of five digits.
	Card No.:			One digit. 0 when the channel configuration mode is AUTO. Or
				the slot number (1 to 4) that installs the switch module when the
				mode is NORMAL.
	Channel No.:			First two digits: specifies input port. 01 to 14.
				Last two digits: specifies output port. 01 to 12, 01 to 24, 01 to
				36, or 01 to 48 for the AUTO mode. It depends on the number
				of modules installed in the mainframe from slot number 1
				continuously. Or 01 to 12 for the NORMAL mode
				See Figure 1-4.
Figure 4-1	Syntax of channel_list Parameter
					,
		(	@	Card No. Channel No.		:	Card No.	Channel No.		)
				(1digit)	(4 digits)		i	(4 digits)
							(1digit)

Agilent B2200 User’s Guide, Edition 2 4-5