Agilent Technologies B2201A manual Connector Plates, Agilent Model No Description, Output Cable

	Installation
	Output Connections
	Connector Plates
	Connector plates (Table 2-2) are used for the connection between the Agilent B2200
	outputs and the DUT interface (prober and so on). To connect to the connector plate,
	use the cable shown in Table 2-3.
Table 2-2	Connector Plate
Agilent Model No.	Description
16495F	Half size connector plate
	16495F-001 has 12 triaxial through connectors (female to female), an Intlk
	connector, and a GNDU connector (triaxial through, female to female). The back
	of the Intlk connector is designed for soldering.
	16495F-002 has 12 triaxial connectors, an Intlk connector, and a GNDU
	connector. The back of each connector is designed for soldering.
16495G	Full size connector plate
	16495G-001 has 24 triaxial through connectors (female to female), an Intlk
	connector, and a GNDU connector (triaxial through, female to female). The back
	of the Intlk connector is designed for soldering.
	16495G-002 has 24 triaxial connectors, an Intlk connector, and a GNDU
	connector. The back of each connector is designed for soldering.
16495E	Blank plate
	This plate is used to cover openings when you made too big openings for
	mounting the connector plate. You will use this plate to cover openings if you
	mount the half size connector plate in openings made for the full size connector
	plate.
Table 2-3	Output Cable
Agilent Model No.	Description
16494A	Triaxial cable (for non-Kelvin connection)
16494B	Kelvin Triaxial cable (for Kelvin connection)
	Installing Connector Plate
NOTE
	To install the connector plate, refer to Agilent 16495 Installation Guide.

2-12 Agilent B2200 User’s Guide, Edition 2