Agilent Technologies B2201A manual ROUTeAGNDCHANnelENABleLIST

SCPI Command Reference [:ROUTe]:AGND:CHANnel:ENABle[:LIST]

Syntax	[:ROUTe]:AGND:CHANnel:ENABle:CARD card_number
	Parameter	Explanation
	card_number	For Auto Config mode: 0 or ALL
		For Normal Config mode: 1, 2, 3, 4, or ALL
Example	OUTPUT @Agb2200;":ROUT:AGND:CHAN:ENAB:CARD ALL"
	[:ROUTe]:AGND:CHANnel:ENABle[:LIST]
	This command specifies the ground-enabledoutput ports (channels). When the
	Ground Mode is ON, the ground-enabledoutput ports that have not been connected
	to any other input port are connected to the input Ground Port. Then, the input
	Ground Port will not be connected to the output ports that have been connected to
	any other input port. At *RST, no channel is ground-enabled. The ground mode is
	set by “[:ROUTe]:AGND[:STATe]”.
	The query returns whether the specified channels are ground-enabled or not.
Syntax	[:ROUTe]:AGND:CHANnel:ENABle[:LIST] (@channel_list)
	[:ROUTe]:AGND:CHANnel:ENABle[:LIST]? (@channel_list)
	Parameter	Explanation
	channel_list	Channels to ground-enable or to check.
		For channel_list, see “Switch Control” on page 4-5.
	Input port is always the input Ground Port. So, the input ports in channel_list are
	ignored. However, you cannot abbreviate the input port number.
Query response	enable_status{, enable_status} <newline><^END>
	1: ground enabled
	0: ground disabled
Example	OUTPUT @Agb2200;":ROUT:AGND:CHAN:ENAB (@10101)"
	OUTPUT @Agb2200;":ROUT:AGND:CHAN:ENAB? (@10101,10102,10201)"
	ENTER @Agb2200;A$

This example ground-enables the output port 1 on the card 1. In this example, A$ will be 1,0,1.

5-26 Agilent B2200 User’s Guide, Edition 2