Agilent Technologies B2201A manual ROUTeBIASCHANnelDISableCARD, ROUTeBIASCHANnelDISableLIST

SCPI Command Reference [:ROUTe]:BIAS:CHANnel:DISable:CARD

[:ROUTe]:BIAS:CHANnel:DISable:CARD

This command bias-disables the all output ports (channels) for the specified card. When the Bias Mode is ON, the bias-disabledoutput ports are disconnected from the input Bias Port. At *RST, all cards are bias-enabled. The bias mode is set by “[:ROUTe]:BIAS[:STATe]”.

Syntax	[:ROUTe]:BIAS:CHANnel:DISable:CARD card_number
	Parameter	Explanation
	card_number	For Auto Config mode: 0 or ALL
		For Normal Config mode: 1, 2, 3, 4, or ALL
Example	OUTPUT @Agb2200;":ROUT:BIAS:CHAN:DIS:CARD ALL"
	[:ROUTe]:BIAS:CHANnel:DISable[:LIST]
	This command specifies the bias-disabledoutput ports (channels). When the Bias
	Mode is ON, the bias-disabledoutput ports are disconnected from the input Bias
	Port. At *RST, all channels are bias-enabled. The bias mode is set by
	“[:ROUTe]:BIAS[:STATe]”.
	The query returns whether the specified channels are bias-disabled or not.
Syntax	[:ROUTe]:BIAS:CHANnel:DISable[:LIST] (@channel_list)
	[:ROUTe]:BIAS:CHANnel:DISable[:LIST]? (@channel_list)
	Parameter	Explanation
	channel_list	Channels to bias-disable or to check.
		For channel_list, see “Switch Control” on page 4-5.
	Input port is always the input Bias Port. So, the input ports in channel_list are
	ignored. However, you cannot abbreviate the input port.
Query response	disable_status{, disable_status} <newline><^END>
	1: bias disabled
	0: bias enabled

5-30 Agilent B2200 User’s Guide, Edition 2