Agilent Technologies B2201A manual ROUTeBIASPORT

	SCPI Command Reference
	[:ROUTe]:BIAS:PORT
	Input port is always the input Bias Port. So, the input ports in channel_list are
	ignored. However, you cannot abbreviate the input port.
Query response	enable_status{, enable_status} <newline><^END>
	1: bias enabled
	0: bias disabled
Example	OUTPUT @Agb2200;":ROUT:BIAS:CHAN:DIS:CARD ALL"
	OUTPUT @Agb2200;":ROUT:BIAS:CHAN:ENAB (@10101)"
	OUTPUT @Agb2200;":ROUT:BIAS:CHAN:ENAB? (@10101,10102,10201)"
	ENTER @Agb2200;A$
	This example bias enables the output port 1 on the card 1. In this example, A$ will
	be 1,0,1.
	[:ROUTe]:BIAS:PORT
	If the input bias port and a couple port have been assigned to the same input port, the
NOTE
	bias mode and the couple mode cannot be used in parallel.
	This command specifies the input Bias Port for the specified card. For each card,
	you can specify the same or different Bias Port. At *RST, Bias Port is set to 10. The
	bias mode is set by “[:ROUTe]:BIAS[:STATe]”. The query returns the input Bias
	Port number for the specified card.
Syntax	[:ROUTe]:BIAS:PORT card_number,bias_port
	[:ROUTe]:BIAS:PORT? card_number
	Parameter	Explanation
	card_number	For Auto Config mode: 0 or ALL
		For Normal Config mode: 1, 2, 3, 4, or ALL
		ALL is not available for query.
	bias_port	Input port number: 1 to 14. Or -1to disable bias port.
Query response	port_number <newline><^END>
	port_number = 1 to 14 or -1. Number set to bias_port.
Example	OUTPUT @Agb2200;":ROUT:BIAS:PORT ALL,4"
	OUTPUT @Agb2200;":ROUT:BIAS:PORT? 1"
	ENTER @Agb2200;A

5-32 Agilent B2200 User’s Guide, Edition 2