Agilent Technologies B2201A manual ROUTeBIASCHANnelENABleCARD, ROUTeBIASCHANnelENABleLIST

		SCPI Command Reference
		[:ROUTe]:BIAS:CHANnel:ENABle:CARD
Example	OUTPUT @Agb2200;":ROUT:BIAS:CHAN:ENAB:CARD ALL"
	OUTPUT @Agb2200;":ROUT:BIAS:CHAN:DIS (@10101)"
	OUTPUT @Agb2200;":ROUT:BIAS:CHAN:DIS? (@10101,10102,10201)"
	ENTER @Agb2200;A$
	This example bias-disables the output port 1 on the card 1. In this example, A$ will
	be 1,0,1.
	[:ROUTe]:BIAS:CHANnel:ENABle:CARD
	This command bias-enables the all output ports (channels) for the specified card.
	When the Bias Mode is ON, the bias-enabledoutput ports that have not been
	connected to any other input port are connected to the input Bias Port. This
	command is available only for the specified card. At *RST, all cards are
	bias-enabled. The bias mode is set by “[:ROUTe]:BIAS[:STATe]”.
Syntax	[:ROUTe]:BIAS:CHANnel:ENABle:CARD card_number
	Parameter	Explanation
	card_number	For Auto Config mode: 0 or ALL
		For Normal Config mode: 1, 2, 3, 4, or ALL
Example	OUTPUT @Agb2200;":ROUT:BIAS:CHAN:ENAB:CARD ALL"
	[:ROUTe]:BIAS:CHANnel:ENABle[:LIST]
	This command specifies the bias-enabledoutput ports (channels). When the Bias
	Mode is ON, the bias-enabledoutput ports that have not been connected to any
	other input port are connected to the input Bias Port. Then, the input Bias Port will
	not be connected to the output ports that have been connected to any other input
	port. At *RST, all channels are bias-enabled. The bias mode is set by
	“[:ROUTe]:BIAS[:STATe]”.
	The query returns whether the specified channels are bias-enabled or not.
Syntax	[:ROUTe]:BIAS:CHANnel:ENABle[:LIST] (@channel_list)
	[:ROUTe]:BIAS:CHANnel:ENABle[:LIST]? (@channel_list)
	Parameter	Explanation
	channel_list	Channels to bias-enable or to check.
		For channel_list, see “Switch Control” on page 4-5.

Agilent B2200 User’s Guide, Edition 2 5-31