Agilent Technologies B2201A manual ROUTeAGNDCHANnelDISableLIST, ROUTeAGNDCHANnelENABleCARD

SCPI Command Reference [:ROUTe]:AGND:CHANnel:DISable[:LIST]

[:ROUTe]:AGND:CHANnel:DISable[:LIST]

This command specifies the ground-disabledoutput ports (channels). When the Ground Mode is ON, the ground-disabledoutput ports are disconnected from the input Ground Port. At *RST, no channel is ground-enabled. The ground mode is set by “[:ROUTe]:AGND[:STATe]”.

The query returns whether the specified channels are ground-disabled or not.

Syntax	[:ROUTe]:AGND:CHANnel:DISable[:LIST] (@channel_list)
	[:ROUTe]:AGND:CHANnel:DISable[:LIST]? (@channel_list)
	Parameter	Explanation
	channel_list	Channels to ground-disable or to check.
		For channel_list, see “Switch Control” on page 4-5.
	Input port is always the input Ground Port. So, the input ports in channel_list are
	ignored. However, you cannot abbreviate the input port.
Query response	disable_status{, disable_status} <newline><^END>
	1: ground disabled
	0: ground enabled
Example	OUTPUT @Agb2200;":ROUT:AGND:CHAN:DIS (@10101)"
	OUTPUT @Agb2200;":ROUT:AGND:CHAN:DIS? (@10101,10102,10201)"
	ENTER @Agb2200;A$

This example ground-disables the output port 1 on the card 1. In this example, A$ will be 1,0,1.

[:ROUTe]:AGND:CHANnel:ENABle:CARD

This command ground-enables the all output ports (channels) for the specified card. When the Ground Mode is ON, the ground-enabledoutput ports that have not been connected to any other input port are connected to the input Ground Port. This command is available only for the specified card. At *RST, no channel is ground-enabled. The ground mode is set by “[:ROUTe]:AGND[:STATe]”.

Agilent B2200 User’s Guide, Edition 2 5-25