Agilent Technologies B2201A manual Selftest

		Front Panel Operation
		Setup Menus
SELF_TEST	Displays the sub menu that provides the following functions.
	•	EXECUTE
		Starts the controller test. Wait until PASS or FAIL is displayed. Then press the
		Exit key to return to the previous menu.
	•	RESULT
		Displays the test result. Press the Exit key to return to the previous menu.
RELAY_TEST	Displays the sub menu that provides the following functions.
	Before starting the relay test, disconnect cables from the input connectors. And open
	the outputs (end of cable is OK). For the Kelvin cable, disconnect it from the output
	connectors.
	•	EXECUTE
		Displays the following message.
		Slot1
		Press the up or down arrow key to select the module to be tested. Then press the
		Enter key to start the relay test, or press the Exit key to cancel this operation.
		Number of modules is 2 or more, the relay test will be automatically completed.
		However, if the only one module is installed, the following message will appear.
		Connect IV1 and 2. Press [Enter].
		Then connect a cable between the input 1 and 2, and press Enter key.
		After that, change the cable connection as shown in the displayed message and
		repeat this for the other input connections (input 3 and 4, 5 and 6, 7 and 8, 9 and
		10, 11 and 12, 13 and 14). Do not forget to open the connectors other than the
		specified pair.
	•	RESULT
		Displays the following message (example). Press the up or down arrow key to
		display the test result for each module. Press the Exit key to return to the
		previous menu.

Slot1: Not performed yet

Agilent B2200 User’s Guide, Edition 2 3-35