Agilent Technologies B2201A manual Sequence

Front Panel Operation

Front Panel Keys

Bias Mode	Sets the bias mode ON or OFF.
	When the bias mode is set to ON, the LCD shows which input port is the bias port,
	and the input bias port will be connected to the bias-enabled channels that are not
	connected to other input port. And LEDs will be turned red to show the bias port
	connections.

Ch Mode (Shift+ Bias Mode)

Couple Mode

Sets the channel configuration mode AUTO or NORMAL.

Changing the mode will reset the Agilent B2200 settings.

Sets the couple mode ON or OFF.

When the couple mode is set to ON, the LCD shows which input ports are the couple port.

Gnd Mode (Shift+ Couple Mode)

Sets the ground mode ON or OFF.

When the ground mode is set to ON, the LCD shows which input port is the ground port, and the input ground port will be connected to the ground-enabled channels that are not connected to other input port. And LEDs will be turned red to show the ground port connections. The ground enabled input ports are also connected to the input ground port. Nothing must be connected to the ground enabled input ports.

Rule	Displays the following message. Selects the connection rule FREE (plural route
	connections) or SINGLE (single route connection).
	FREE
Sequence	Displays the following message. Selects the connection sequence
(Shift+Rule)	Break_Before_Make, Make_Before_Break, or No_Sequence.
	Break_Before_Make
Load Memory	Displays the following message. Used to select the Agilent B2200 setup data stored
	in the internal memory, and loads the data.
	Settings: 01 [	]
Save Memory	Displays the following message. Used to select the internal memory to store the
(Shift+	Agilent B2200 setup data, and stores the data. Up to eight setup data can be saved.
Load Memory)	Settings: 01 [	]
Open All	Displays the following message. Press the arrow key to set YES, and then press the
	Enter key to open all relays.

NO

Agilent B2200 User’s Guide, Edition 2 3-27