Agilent Technologies N9030a manual Hardware and Firmware Requirements for N9061A

Getting Started

Hardware and Firmware Requirements for N9061A

Hardware and Firmware Requirements for N9061A

One of the following Agilent signal analyzers is required to run the N9061A application.

Table 1-1	Compatible Agilent PXA Series Signal Analyzers
Analyzer Model		Upper Frequency Limit	Firmware
Number
N9030A-503		3.6 GHz	Rev A.04.00 or later
N9030A-508		8.4 GHz	Rev A.04.00 or later
N9030A-513		13.6 GHz	Rev A.04.00 or later
N9030A-526		26.5 GHz	Rev A.04.00 or later

Table 1-2	Compatible Agilent MXA Series Signal Analyzers
Analyzer Model		Upper Frequency Limit	Firmware
Number
N9020A-503		3.6 GHz	Rev A.01.64 or later
N9020A-508		8.4 GHz	Rev A.01.64 or later
N9020A-513		13.6 GHz	Rev A.01.64 or later
N9020A-526		26.5 GHz	Rev A.01.64 or later

Table 1-3	Compatible Agilent EXA Series Signal Analyzers
Analyzer Model		Upper Frequency Limit	Firmware
Number
N9010A-503		3.6 GHz	Rev A.01.64 or later
N9010A-507		7 GHz	Rev A.01.64 or later
N9010A-513		13.6 GHz	Rev A.01.64 or later
N9010A-526		26.5 GHz	Rev A.01.64 or later

For maximum compatibility, you should select an X-Series analyzer that equals or exceeds the frequency range of the legacy analyzer you are replacing (currently not possible for the 8564E/EC or 8565E/EC). The frequency limits of the legacy instruments are listed below.

Table 1-4	Frequency Ranges of the Legacy Analyzers
Remote Language		Start Frequency	Stop Frequency
8560E/EC		30 Hz	2.9 GHz
8561E/EC		30 Hz	6.5 GHz

23